Black Mega Chutes garbage bag falling through a clear trash chute

Brooklyn, New York · Fabrication + installation

Trash chutes
and compactors,
built in the shop.

We build chute and compactor systems ourselves and put them in with our own crew — new construction and compactor chutes, in buildings across New York City and New Jersey.

Floor count, landing layout, and the building address get you a lead time · one bag, one chute, roof to compactor

Fabrication
In-house
Installation
Our own crew
Base
Brooklyn, NY
Scope
Chutes + compactors
01

What we build

Two jobs, one shop behind them. If your scope sits between them, send it anyway and we'll say who does what.

A

New construction chute systems

Chute trunk, landing doors at every floor, and the discharge at the low point — built to the shaft you're framing, not adjusted to it after the fact.

Measured from your drawings and checked on site before anything is cut.

B

Compactor chute systems

Chute, hopper, and compactor arranged as one system so the room works: the compactor fills properly, the chute drains, and the crew has room to service it.

Works with the compactor you've specified, or we tell you what won't fit.

02

How the work runs

Four stages, and the same people on the end of them from the site check through to handover.

01

Site check

We look at the shaft, the landings, and where the dump lands. Measurements off a drawing are a starting point; the building decides.

02

Shop build

Sections are cut, formed, and assembled in our own shop so the stack arrives ready to stand up, not ready to be argued with.

03

Delivery and install

Our crew brings the truck, sets the sections, aligns every landing, and ties into the compactor or the dump.

04

Handover

Doors checked, room cleared, and you get a chute that closes, seals, and drains the way it was drawn.

03

Where it goes in

Chute landings, compactor rooms, shafts, and the street-side enclosure. This is where the work lives.

Grey chute landing door with key lock installed in a finished corridor alcove
Landing door · finished alcove
Blue compactor fed by a stainless chute in a tiled compactor room
Compactor room · chute tie-in
Stainless chute stack with intake standing inside steel stud framing
Chute stack · during framing
Refuse chute door above a wash out door on a landing wall
Refuse door + wash out door
Galvanised chute vent with conical cap on a Brooklyn rooftop
Rooftop vent · Brooklyn
Blue compactor under a black chute discharge in a concrete basement
Basement compactor · discharge

On site

Compactor installed and running

Chute discharge, compactor, and bagging set up and tested before we hand the room over.

04

Who we work with

  • General contractors
  • Developers
  • Property managers
05

Where we work

Based in Brooklyn, working across the five boroughs and into New Jersey. Outside that, call and ask — it depends on the job and the distance.

  • Brooklyn
  • Queens
  • Manhattan
  • Bronx
  • Staten Island
  • New Jersey
Mega Chutes

Tell us what the building needs.

Drawings, a floor count, and the address — that's enough for us to come back with a lead time.

Call (718) 682-2723Get a quote